|
PONIC XP 5100
|
|
|
XP 5100
- 2500W + 2500W @ 2 Ohm;
5000W @ 4 Ohm bridged
- Two low pass filters
with selectable frequencies at 60, 90 or 120 Hz for
subwoofer use
- Dual mono, high current
power supply for increased reliability and performance
- High-current toroidal
transformers for greater two-ohm power and low noise
- Independent
user-defeatable clip limiters reduce distortion
- Selectable high pass
filters (30 Hz or 50 Hz) protect speakers and increase
headroom
- Balanced 1/4" (6.3 mm)
TRS, XLR, and barrier strip inputs for maximum flexibility
- Binding post and
Speakon®-type outputs
- Selectable stereo,
parallel & bridge mono amp modes
- Ground lift switch to
prevent hum
- Signal level at -40,
-20, -10, protect and clip LED indicators to monitor
performance
- Bridge mono and
parallel mode indicators
- Front mounted detented
gain controls for easy access
- Fast Recovery design
for lower distortion at clipping
- Advance protection
circuitry guards against: short circuit, open circuit,
thermal, ultrasonic, and RF protection, stable into
mismatched loads, on/off muting, DC fault output crowbar
- Three rack unit high
|
|
|
|
PONIC XP 5000
|
|
|
XP 5000
- 2500W + 2500W @ 2 Ohm;
5000W @ 4 Ohm bridged
- Dual mono, high current
power supply for increased reliability and performance
- High-current toroidal
transformers for greater two-ohm power and low noise
- Independent
user-defeatable clip limiters reduce distortion
- Selectable high pass
filters (30 Hz or 50 Hz) protect speakers and increase
headroom
- Balanced 1/4" (6.3 mm)
TRS, XLR, and barrier strip inputs for maximum flexibility
- Binding post and
Speakon®-type outputs
- Selectable stereo,
parallel & bridge mono amp modes
- Ground lift switch to
prevent hum
- Signal level at -40,
-20, -10, protect and clip LED indicators to monitor
performance
- Bridge mono and
parallel mode indicators
- Front mounted detented
gain controls for easy access
- Fast Recovery design
for lower distortion at clipping
- Advance protection
circuitry guards against: short circuit, open circuit,
thermal, ultrasonic, and RF protection, stable into
mismatched loads, on/off muting, DC fault output crowbar
- Three rack unit high
|
|
|
|
PONIC XP 3100
|
|
|
XP 3100
- Advanced powerful
performance 3rd generation circuitry design
- Output power: 1000W @ 4
ohms, 1400W @ 2 ohms
- Front mounted two low
pass filters and two gain controls
- High continuous current
output from robust toroidal transformer
- Switchable input peak
limiter and selectable high pass filter (30Hz, 50Hz) to
reduce distortion and protect speakers
- Bridge mono and
parallel mode LEDs
- Fast Recovery design
for lower distortion if clipping occurs
- Very rugged housing
- Active balanced inputs
for low noise
- Signal level at -40,
-20, -10, protect and clip LED indicators to monitor
performance
- Ground Lift switch to
prevent humming
- Selectable stereo,
parallel & bridge mono amp modes
- Two ventilation
variable speed fans
- Speakon®-type
connectors and 5-way binding posts speaker outputs
- XLR & 1/4" TRS
connectors for maximum input flexibility
- Requires three standard
rack units for mounting
- Fits a standard 19"
rack
|
|
|
|
PONIC XP 3000
|
|
|
XP 3000
- 2500W + 2500W @ 2 Ohm;
5000W @ 4 Ohm bridged
- Dual mono, high current
power supply for increased reliability and performance
- High-current toroidal
transformers for greater two-ohm power and low noise
- Independent
user-defeatable clip limiters reduce distortion
- Selectable high pass
filters (30 Hz or 50 Hz) protect speakers and increase
headroom
- Balanced 1/4" (6.3 mm)
TRS, XLR, and barrier strip inputs for maximum flexibility
- Binding post and
Speakon®-type outputs
- Selectable stereo,
parallel & bridge mono amp modes
- Ground lift switch to
prevent hum
- Signal level at -40,
-20, -10, protect and clip LED indicators to monitor
performance
- Bridge mono and
parallel mode indicators
- Front mounted detented
gain controls for easy access
- Fast Recovery design
for lower distortion at clipping
- Advance protection
circuitry guards against: short circuit, open circuit,
thermal, ultrasonic, and RF protection, stable into
mismatched loads, on/off muting, DC fault output crowbar
- Three rack unit high
|
|
|
Per
qualsiasi informazione sulla disponibilitą dei prodotti
contattare i nostri uffici.
Per
eventuali variazioni di prezzo dei singoli prodotti a listino,
si prega di rivolgersi al settore marketing.
Le
caratteristiche tecniche ed eventuali prezzi dei prodotti
sopra citati, possono subire variazioni senza preavviso.
Prezzi validi salvo conferma in sede d'ordine.
|
